Kenlowe Hot Start (Pre Heater 240v)

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
P

plastic soul

Active Member
Posts
432
Does anyone have any info on which pipes to use for these?

I have connected it to the output from the heater matrix (the one the goes in the back of the engine on the top) to the input of the unit, then the output from the input to the engine.

It's not pushing heat around...after an hour...not a lot

I HAVE bled the system...no air etc...I know the unit works cus I tested it....

I am better off using the output from the engine as the input to the unit then push the hot water straight to the matrix instead? Will this make a difference?
 
plastic soul said:
Does anyone have any info on which pipes to use for these?

I have connected it to the output from the heater matrix (the one the goes in the back of the engine on the top) to the input of the unit, then the output from the input to the engine.

It's not pushing heat around...after an hour...not a lot

I HAVE bled the system...no air etc...I know the unit works cus I tested it....

I am better off using the output from the engine as the input to the unit then push the hot water straight to the matrix instead? Will this make a difference?
Click to expand...

well, it would heat the matrix quicker if you want the hot air.
 
Is it the old square model or the newer cylindrical one. I think the old square one is a heater only - it needed a pump to circulate any heated fluid. Not sure if the newer cylindrical model has a pump built in or not.

Might be talking Horlicks!
 
plastic soul said:
it's the older square one, does have a pump, tested it in the kitchen all fine
Click to expand...

Same as the one I had fitted to my old RR which was plumbed into the engine-block as u did then with V8s... so just an engine heater :
Never missed not having one fitted on any other car I've owned, it never gets that cold in my part of the world -8c once :D.
 
Last edited:
is it not supposed to be connected to the rad pipes, to heat the engine block to make sure it's warm to prevent damage. when it heats the water up it would open the thermostat and then start to heat the matrix??
Or another thought, is the temp turned up on the dial in the cab? also the air around the matrix won't be moving as the car fan wouldn't be on.
 
heggars said:
Or another thought, is the temp turned up on the dial in the cab? also the air around the matrix won't be moving as the car fan wouldn't be on.
Click to expand...

No, this is a Discovery not a bloody series 3 :rolleyes:

You only disrupt one pipe, and that is the one that you want the heat to be absorbed first, so, you need to be sure of the direction of pumping and the flow of water from the engine then if you want to heat the cabim matrix first you put it on the pipe that flows from the engine to the matrix, or vice versa if you are wanting to pre-heat the engine more than the interior, either way it makes little odds as something is better than nothing.

The direction of flow and the direction of pumping are the important bits, and only disturb one pipe as it really only connects a loop in the circuit.
 
You must log in or register to reply here.

Similar threads

V
300 TDI EDC, No fuel to injectors
Replies
17
Views
1K
BIGrabbit100
B
G
Series three heater matrix blowing cold
Replies
11
Views
1K
Citizen Kane
C
E
300tdi D1 Bleeding Coolant
Replies
10
Views
788
Stanleysteamer
Stanleysteamer
R
Heater low temperature, lack of power, connected?
2
Replies
26
Views
2K
Russell Marlow
R
S
Windscreen Wiper switch question
Replies
4
Views
1K
TS2304
TS2304
Back
Top