Just wondering if....

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
D90mitch

D90mitch

Well-Known Member
Posts
2,419
Location
Sometimes Peterborough, Sometimes Hatfield
Could anyone one here make me a straight through tail pipe for me 200tdi 90? As I cant weld, I cant really make one myself. Looking for one on the dirt cheap side :D. But then again how expensive can it be for such a short section of pipe?

Cheers :D
 
U can buy straight thro pipe but I think the rules of mot now has changed. Not sure mate my ex mod na has box in middle and the tester said that has to be fitted but the rear silencer don't.
 
There is only one straight through tail pipe for the 200tdi that I can find and its £105 from Janspeed. It says it wouldn't fit without the mid pipe but I think that's bollox going off the image.... Anyway ill give someone £50 if they make me a reasonable one ;)
 
I had a local landy garage (Herts) cut out and weld in a bit of pipe to replace the center box. This wasn't enough for me so I replaced the back box myself. It wasn't that hard. Its not welded at the moment however if it does look like its going to fall apart then ill get it welded together. Its pretty solid though. My exhaust mod
 
Yes I did see your thread, I already have a straight through mid pipe so that's fine, Because the mid pipe finishes in the inside of the chassis, higher up, it makes things difficult. Also, ignore my stupidity, how would I clamp a flexi pipe or whatever to the mid pipe when the end is flared to accept the back box?
 
You must log in or register to reply here.

Similar threads

C
Roll cage to support expedition roof rack?
Replies
13
Views
2K
ER1C
ER1C
H
Landrover insurance
2
Replies
24
Views
4K
dag019
dag019
W
Stubborn Fuel Filter Remical
Replies
5
Views
410
Whiston90Gurt
W
s8ndst0rm
200TDI Crank, No Start - Investigation Thread
2
Replies
32
Views
3K
dag019
dag019
A
Td5 silencer removal.
Replies
4
Views
1K
Anaconda
A
Back
Top