Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
Ive found out why my 4.6 were tickin
- Thread starter Sirus
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Tervueren
New Member
- Posts
- 646
Looks like a typical made from liquorice cam to me 
Any good http://www.pipercams.co.uk/NewPiperWeb/redesign/05cams/rover_serpentine_cam.pdf
Any good http://www.pipercams.co.uk/NewPiperWeb/redesign/05cams/rover_serpentine_cam.pdf
- Posts
- 83,310
- Location
- Embasinga stocæ
real steel do good cams for rover injuns.
After the engine were rebuilt 15 mnths ago the car has got slower and slower on the pick up......
found out why
1400 miles later
jeeesh thats shockin , 1400 miles !!
can ya not send the cam back ??? thats bad that is ...
Seen that before when fookers dunt change both cam and followers at same time. If yer lifters have a big dish on them chances is thats what happened. Yer photo's not clear enough to tell if thats the case, but old followers destroy a cam.
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
it was all replaced.....it been replaced again now free of charge. should think so too
Dorset VogueSE
Well-Known Member
- Posts
- 1,259
Yes but what about the bit of the cam that aint part of the cam anymore. Would be interestin to know what all them little bits of metal have been doing to the rest of the engine????
