Inner wing foam?

tankduck · Jan 25, 2011

Afternoon guys,
did my chassis swap over xmas, is all looking sexy but I got quite a bit of vibration that weren't there before, mainly where sealant and stuff perished and I haven't replaced it as I don't want moisture trapped! I do remember these big chunks of foam inbetween the inner wing and chassis rail, think they were stuck to the chassis actually. Is this common on a 200tdi 90 or does it sound like someone stuck it there?

bevhelee · Jan 25, 2011

Think you'll find they are there to stop vibration

jamesmartin · Jan 25, 2011

i would say someone put it there

tankduck · Jan 25, 2011

Yeah its a tricky one, can't find them on any of the websites and can't find anyone else mentionning them on forums, can't be a good idea to have foam soaking up water and mud surely?

Litch · Jan 25, 2011

Sounds like someone did it instead of adjusting the inner wing so it was away from the chassis.

dazzx10r · Jan 25, 2011

well it must be a coincidence then, because mine had the stuff fitted to the lower edge of the inner wing as it goes up against the chassis/bulkhead. Was it an oblonged section about 1 1/2"x 1" and about 12" long?

Discoandy · Jan 25, 2011

its there om my 1992 and dads 1989

Inner wing foam?

tankduck

Active Member

bevhelee

Well-Known Member

jamesmartin

Well-Known Member

tankduck

Active Member

Litch

Well-Known Member

dazzx10r

Active Member

Discoandy

New Member

Similar threads