I'm having problems fitting my CB radio on my disco 1 any help much appreciated

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
D

Discodiva200tdi

New Member
Posts
32
Location
surrey
Hi guys

I wonder if you can help ?

I have fitted my cb as per instructions as well as the arial again as per instructions but for some reason it comes on but there is no sound out or in any ideas ?
:confused:
 
What model is it?
Is there a squelch dial? If so then turn this down as it cuts out interference for when you are not receiving anything. If you have someone nearby with a fitted working one then it is best to have them around so you can test properly.
 
With the squelch turned down and the volume up you should be getting a load of static through it.

I would probably go back to the seller about it as it sounds like the speaker could be blown.

There is usually a 3.5mm jack for plugging in an external speaker on the back if you have one then try it and that will let you know where the fault is but it sounds more likely that you might have got a duff one.
 
chezvegas said:
With the squelch turned down and the volume up you should be getting a load of static through it.

I would probably go back to the seller about it as it sounds like the speaker could be blown.

There is usually a 3.5mm jack for plugging in an external speaker on the back if you have one then try it and that will let you know where the fault is but it sounds more likely that you might have got a duff one.
Click to expand...

I'm getting the static through the speaker so don't think theres a problem there thinking maybe the aerial isnt earthed correctly will try and sort that and see if it helps.
 
On my thunderpole t 1000 it came pre set to the euro frequencies which are legal in the uk but don't pick up the uk bands.

Have a look in the instruction manual about changing frequencies (its just a combination of turning on and off and pressing buttons) as it sounds like that could be the problem.
 
chezvegas said:
On my thunderpole t 1000 it came pre set to the euro frequencies which are legal in the uk but don't pick up the uk bands.

Have a look in the instruction manual about changing frequencies (its just a combination of turning on and off and pressing buttons) as it sounds like that could be the problem.
Click to expand...

Yeah mine was the same. The nice gentleman in the shop sorted mine for me before I left with it or I would probably have been in the same predicament :doh:
 
chezvegas said:
On my thunderpole t 1000 it came pre set to the euro frequencies which are legal in the uk but don't pick up the uk bands.

Have a look in the instruction manual about changing frequencies (its just a combination of turning on and off and pressing buttons) as it sounds like that could be the problem.
Click to expand...

Mine the same. Felt such a fool when a more knowledgeable member just switched it from the eu channels to the UK bands.:eek:
 
You must log in or register to reply here.

Similar threads

A
Discovery 2. Question about auto box replacement, help most appreciated!
Replies
5
Views
797
Stanleysteamer
Stanleysteamer
LukeyT
Disco 2 Disco 2 Electrical Issue Interior Lights, Radio, Heater Controls and Immobiliser
Replies
6
Views
578
LukeyT
LukeyT
B
TD5 problems in the wet
Replies
10
Views
905
BlueberryTD5
B
T
Any problems changing from 265/75/16 on disco 1 alloys to 235/85/16 or 7.5 r16 on steels?
Replies
3
Views
419
Dr Strangeglove
D
D
3.9 V8 auto 14CUX limp mode/no power
Replies
3
Views
840
AllanWorms
AllanWorms
Back
Top