raywin
Well-Known Member
- Posts
- 3,808
- Location
- North Yorkshire
Just wondered if anyone could help me out with a problem on my 2010 Freelander 2
The car does not have factory fitted GPS or reversing camera and I wanted to have these things, so I bought one of the Xtrons Android units which would offer both,
unit is avalible on tbay see:
https://www.ebay.co.uk/itm/XTRONS-A...583453?hash=item3d8af9101d:g:ROoAAOSwwl9c3QiI
Everything was going OK ( I hate working on car interiors and trim) until time to plug in the "piggyback" cable which goes between the original radio plug and the radio to give the necessary connections to the new unit.
My plugs are different and reading up on this I suspect mine are a Ford standard (apparently used on the Ford KA) where the xtrons unit has a DIN standard plug but I am not sure if this is really the case.
Can anyone help me here is there an adaptor available to do this or am I stuck with either chop the xtrons wires into the radio loom or bin the whole project?
below is the situation Red plug goes into my existing LR radio along with another smaller one
Grey plugs are on the Xtrons "piggyback" cable which should be plugged into the radio at one end and the red plug below into the female end.
The car does not have factory fitted GPS or reversing camera and I wanted to have these things, so I bought one of the Xtrons Android units which would offer both,
unit is avalible on tbay see:
https://www.ebay.co.uk/itm/XTRONS-A...583453?hash=item3d8af9101d:g:ROoAAOSwwl9c3QiI
Everything was going OK ( I hate working on car interiors and trim) until time to plug in the "piggyback" cable which goes between the original radio plug and the radio to give the necessary connections to the new unit.
My plugs are different and reading up on this I suspect mine are a Ford standard (apparently used on the Ford KA) where the xtrons unit has a DIN standard plug but I am not sure if this is really the case.
Can anyone help me here is there an adaptor available to do this or am I stuck with either chop the xtrons wires into the radio loom or bin the whole project?
below is the situation Red plug goes into my existing LR radio along with another smaller one
Grey plugs are on the Xtrons "piggyback" cable which should be plugged into the radio at one end and the red plug below into the female end.
