I would just like to say

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
@kevstar as a little kid.
"Guess what I got for Xmas?"
His little mate said "What?"
"An "indestructible toy"."
"So what did you do wiv it?"
"I used it to destroy all my other toys!!!!!"
😂😂😂😂😂

Snot broked any more, I put a 25T shackle on it nearly good as new. Come to think about it I didnt test it, weapon of choice
was the sheer for the afternoons destruction. :D:D
 
When eye fits me water harvester fing to me drain pipe eye need ter run the output along me castle wall, over the top of 4 foot of gate and fence, to me garage guttering. Output on said harvester is 32mm at the end. Tis a slowly tapering fing. Was finking of using this type of connection so eye can gerrit apart if needed. Collar screw lock comoression type. Anyfink stopping me from using it?

 
When eye fits me water harvester fing to me drain pipe eye need ter run the output along me castle wall, over the top of 4 foot of gate and fence, to me garage guttering. Output on said harvester is 32mm at the end. Tis a slowly tapering fing. Was finking of using this type of connection so eye can gerrit apart if needed. Collar screw lock comoression type. Anyfink stopping me from using it?

That one is for 40mm pipe. You can get one for 32mm pipe. Like this one ----

 
Well here where I live it's a minimum £150/day per man.

Well they priced the job and I didnt try and haggle the price, so I guess they earn what they earn.
Price is all relavant though isnt it.
A packet of fags is less than £3, a six pack of beer is less than £3 so to sustain a worker is pretty cheap per day ;).
But whatever the cost it can still be done right. If they get 150 or 50 a day doesnt mean the plaster finish shouldnt be flat:).

J
 
32mm pipe. Is that the internal or hexternal measurement?

Just found a lenf of down pipe and 2m of guttering in ma ippo's garage. Gutter too short fer plan b. One less down pipe to buy.
 
Can't find me caliper to measure me waste pipe. Fink its 40mm. Me harvester is 32.5. End bit narrows to 31 eye fink. Measuring wivvit between two blocks ov wood.
 
Just measured a couple of bits of pipe. 40mm pipe measures 43mm o.d. The 32mm pipe measures 35mm o.d. Measured with a caliper, not blocks of wud :D
 
Back
Top