- Posts
- 7,332
- Location
- Under my landy
Anti Burst locks as used on 'fenders can befitted to Series doors with minor modications...
Parts
395038 - door handle
395037 - door handle
FQB000050 - anti burst catch
FQB000040 - anti burst catch
395056 - locks
Door... Needs an extra hole drilling in it for the lock, best to take the old lock out and line up the new lock to work out where the hole is... I didn't really do a very good job at this...
catches...
On mine (which i'm now thinking might be bent...) the drivers side doesn't line up just bolting the new catch in place of the old one...
However, using one of the spaces from the old catches does the job perfectly:
Door needs a gentle shut to securely shut, however ,a proper little slam for the lock to fully engage and allow it to be locked.
For some reason my passenger side catch needed recessing, so, i cut a hole for it with the dremel...
The bottom slots in and bolts as normal, but i used a longer M10 bolt at the top to brace it against the back of the bulkhead...
Fitted door lock:
Job done...
Drivers side took about 30 - 40 minutes - passenger side took about 1 1/2 hours due to all the fettling to make it work.
Parts
395038 - door handle
395037 - door handle
FQB000050 - anti burst catch
FQB000040 - anti burst catch
395056 - locks
Door... Needs an extra hole drilling in it for the lock, best to take the old lock out and line up the new lock to work out where the hole is... I didn't really do a very good job at this...
catches...
On mine (which i'm now thinking might be bent...) the drivers side doesn't line up just bolting the new catch in place of the old one...
However, using one of the spaces from the old catches does the job perfectly:
Door needs a gentle shut to securely shut, however ,a proper little slam for the lock to fully engage and allow it to be locked.
For some reason my passenger side catch needed recessing, so, i cut a hole for it with the dremel...
The bottom slots in and bolts as normal, but i used a longer M10 bolt at the top to brace it against the back of the bulkhead...
Fitted door lock:
Job done...
Drivers side took about 30 - 40 minutes - passenger side took about 1 1/2 hours due to all the fettling to make it work.
