Holes in Bulkhead.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

jrose

Active Member
Posts
102
Location
Basildon, Essex
Does anyone know what these holes are for in my series 3 109, I tried getting blanking plugs for them but paddock spares don't know what they are, they reckon they are an aftermarket hole.
 

Attachments

  • 20190315_144658.jpg
    20190315_144658.jpg
    339.5 KB · Views: 236
That is the hole for the hand throttle , just measure the diameter of hole and buy a wiring grommet blank to suit.
 

Attachments

  • DSCF1970.JPG
    DSCF1970.JPG
    308.4 KB · Views: 147
  • DSCF1969.JPG
    DSCF1969.JPG
    208.8 KB · Views: 123
Or I could fit a hand throttle for authenticity lol
Not had it long, I pulled the seats forward to clean behind them and the hand cranking bar is still there on its rack. He'd also had the tyres at the right pressures on the wrong axles, quite a difference in driving when they are correct
 
Where can one buy after-market holes? Are they cheap and easier than drilling one's own?
A thought on the dog problem: One could always superglue one's dogs arse to one's new after-market hole.
 
Last edited:
I thought the same, I found out what they were and told them, apparently not all Land Rovers were fitted with them, I might get a hand throttle and fit it, not use it, I think it would look better than a couple of plastic Grommets.
 
Back
Top