My discovery has picked up a fault. After my off roading trip I got home and my high beam dont work at all nor does the flash. Main beam only works if I switch it to high beam or im left with a very dim lights. Not sure ifbits electricak or if its the switch gone. Any way I can find out if its the switch.
high beam problem
- Thread starter grant1985
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
discool
Well-Known Member
- Posts
- 13,695
"Any way I can find out if its the switch".. only with a test meter or substitute with a known working one .
l489owe
Member
- Posts
- 37
- Location
- St neots, centre of the universe
Check and clean all the connectors on the back of the headlamps. I'm no sparky but I have had the same probs in the past and it has been the same connections every time. Good luck.
nrgserv
Well-Known Member
- Posts
- 4,208
- Location
- shipley, west yorks.
Top thread fella. Looks very confusing but im gona give it a go in the next few days only question is I have some crappy little 5amp multimeter is this still ok to use to test on these circuits? Cant wait now but im gona find out somehow what relay is for the lights and start there lol
discool
Well-Known Member
- Posts
- 13,695
You will only be testing for circuit continuity and voltage not high current so you meter is ok.
nrgserv
Well-Known Member
- Posts
- 4,208
- Location
- shipley, west yorks.
post a picture of it, may be able to help us help you.
