Bushtoy
Well-Known Member
- Posts
- 1,998
- Location
- South Africa
did you drop the gearbox to do the change or did you do it in place?
!!help!!
- Thread starter Camshaft
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Bushtoy
Well-Known Member
- Posts
- 1,998
- Location
- South Africa
yup....go to post seven
Oddie
AntiSeptic Sandal Wearer
- Posts
- 26,178
- Location
- In a puddle in Kernow
Will it go into reverse with the engine off? If so what happens if you start in reverse with the clutch down then raise it?
Bushtoy
Well-Known Member
- Posts
- 1,998
- Location
- South Africa
if you gave the gear lever a good whack during the operation, ya could have knocked the adjustment out....i think there is an adjustment on the underside of the gear lever assembly.
Bushtoy
Well-Known Member
- Posts
- 1,998
- Location
- South Africa
sounds to me like its not engaging fully, specially if u say it disengages. if u hold it in reverse, does it still pop out?
GRUNT
Well-Known Member
- Posts
- 8,911
- Location
- On the lake Geneva shoreline.
The reverse gear plunger assembly is just to provide resistance to the lever when reverse is selected so you don't mistake reverse for first, and int adjustable.
GRUNT
Well-Known Member
- Posts
- 8,911
- Location
- On the lake Geneva shoreline.
No. Sounds like the reverse gear selector arm has become dislodged or summat an it's trying to go into two gears at the same time. Apparently it's a common problem.
Bushtoy
Well-Known Member
- Posts
- 1,998
- Location
- South Africa
reverse idler gear runs off first gear when engaged.
Bushtoy
Well-Known Member
- Posts
- 1,998
- Location
- South Africa
yip....not too big a job....dont u have a manual on the box??
Bushtoy
Well-Known Member
- Posts
- 1,998
- Location
- South Africa
Davec
New Member
- Posts
- 2,131
Did you put the right bolts (holding T/box to main G/box) in the right holes.If you put a long bolt in one of the holes meant for a short one it jams something and prevents you engaging reverse. I believe there is something in the latest LRe about it.
Sorry if it all sounds a bit vague, I was only the middleman on the phone between the reconditioner and the customer. We never got another peep out of the customer, and he had been screaming blue murder about warranties until then, so presumably he realised it was his mistake.
Sorry if it all sounds a bit vague, I was only the middleman on the phone between the reconditioner and the customer. We never got another peep out of the customer, and he had been screaming blue murder about warranties until then, so presumably he realised it was his mistake.
