HELP !! Suspension Fault not showing on Text Book !!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

jh61

New Member
Posts
4
Hi

I have a 98 Range Rover 4.6 HSE, i recently had a fault with the front height sensors which have now been replaced. But now since having these done my car sits up higher on front than rear. I took the car to two authorised Land rover dealers who have tried to calibrate but to no avail. The problem i am having is there is no fault showing on text book, so dealer says unable to find problem, sensors are new and correct. All settings on suspension work fine, just does not sit level. The dealer said they where able to calibrate but then once road tested calibration settings seemed to be lost. Also car does seem generally higher all round.

Help !!! Pump is new and also pressure switch.... Has any one ever had this problem .. :confused:


Thanks
Jon
 
Hi

I have a 98 Range Rover 4.6 HSE, i recently had a fault with the front height sensors which have now been replaced. But now since having these done my car sits up higher on front than rear. I took the car to two authorised Land rover dealers who have tried to calibrate but to no avail. The problem i am having is there is no fault showing on text book, so dealer says unable to find problem, sensors are new and correct. All settings on suspension work fine, just does not sit level. The dealer said they where able to calibrate but then once road tested calibration settings seemed to be lost. Also car does seem generally higher all round.

Help !!! Pump is new and also pressure switch.... Has any one ever had this problem .. :confused:


Thanks
Jon
interesting, i think i have similar with one side at front! no new parts though.

i have heard of people calibrating suspension by means of four blocks placed between axle and bump stop as so to start from fresh! this sounds good to me as i had the same reply from testbook, all hights right!
 
Back
Top