Heaters playing up

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Thomo1927

Active Member
Posts
361
Location
South Walian
My 300 tdi discovery heaters are blowing cool ,Head gasket has been changed. Not loosing any water or overheating. Pipes are very warm but it's blowing cold. Heater matrix blocked maybe or something else.

I know you haven't got a crystal ball but any tips for me ? Cheers
 
Is the engine running any cooler than before, if so the thermostat could be stuck open, rare I know.
Are the pipes to the heater matrix hot as they should be, "very warm" how hot is that? I only know cold, warm or hot.
Then there's the blending dampers, is the heater output the same on both sides with the controls set equally?
 
Is the engine running any cooler than before, if so the thermostat could be stuck open, rare I know.
Are the pipes to the heater matrix hot as they should be, "very warm" how hot is that? I only know cold, warm or hot.
Then there's the blending dampers, is the heater output the same on both sides with the controls set equally?

What I have noticed is from start up when I go to work ,The engine temp gets up to just under halfway quicker than it used to. The pipes are hot
 
Tried bleeding the system for 10 mins and can't see any bubbles coming out. The 2 hoses on the rear of the head that go into the matrix ,One is hot and the other is noticeably cooler ? Is that right
 
Update ,Just for the sake of it I put another thermostat in and flushed out the matrix. Lots of black stuff come out ? Took her for a run and bled the system,Loads of air come out .Heaters now very warm .Now I have a happy pregnant Mrs. Cheers everyone
 
Back
Top