Heater cables on a '95 110

HECKFLOSSE · Nov 26, 2015

Please forgive my ignorance, does the air distribution cable join up somewhere under the dash panel?
I suspect it goes to the floor vent flaps but cant see how to get in there.
Any advice most welcome!
Cheers, Jim

Flossie · Nov 26, 2015

You have to drop the whole lower dash off then you will see all the little screws holding the panel that the cable goes through.
It's not hard to do just screws and patience. De rust in side if necessary, check and oil the flaps and make sure they seal well, replace any dodgy foam so All the air from the blower goes where it should and doesn't leak out.

HECKFLOSSE · Nov 27, 2015

Flossie said:
You have to drop the whole lower dash off then you will see all the little screws holding the panel that the cable goes through.
It's not hard to do just screws and patience. De rust in side if necessary, check and oil the flaps and make sure they seal well, replace any dodgy foam so All the air from the blower goes where it should and doesn't leak out.

Thanks.
Not a lunch hour job then!
Jim.

Heater cables on a '95 110

HECKFLOSSE

Active Member

Flossie

Well-Known Member

HECKFLOSSE

Active Member

Similar threads