Heater cable controls

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Buz

Active Member
Posts
766
Whilst doing the chassis swap on my 90 decided to tart up the bulkhead as its in pretty good condition. Refurbing the heater, ordered a new matrix and trying to find replacement cables for the controls. One has broken but I'm thinking change all 3 while it's easier to access them. Does anyone have i/c numbers for them?
Also, what foam did you guys use to replace all the rotten stuff, on the heater door etc, ive ordered replacement seals where it joins bulkhead and air input.
 
Whilst doing the chassis swap on my 90 decided to tart up the bulkhead as its in pretty good condition. Refurbing the heater, ordered a new matrix and trying to find replacement cables for the controls. One has broken but I'm thinking change all 3 while it's easier to access them. Does anyone have i/c numbers for them?
Also, what foam did you guys use to replace all the rotten stuff, on the heater door etc, ive ordered replacement seals where it joins bulkhead and air input.
I used closed cell foam I bought by the roll on eBay, and stuck it down with heat resistant contact adhesive.
 
Also, what foam did you guys use to replace all the rotten stuff, on the heater door etc, ive ordered replacement seals where it joins bulkhead and air input.


I used wide neopreme tape when I did mine.
 
Back
Top