Have my balls had it

Or can I clean them up

If so how I'm doing the swivel bearings and need to know if the balls that use to be chrome are still ok to use they have some pitting

id say they should really be changed

I have some others off another axel that seem a bit better but are the sided as in drivers an passages side or just top and bottom only because they are already off on my work bench and can't remember wot side is wot cheers JM

Only I'm off the road at the minute and my local landy shop is closed till next week as the guy is on holiday

Yes. I changed one with less pitting than that, just didn't want it to grate through the big oil seal and have to do the job again.

I little bit better but not much

I need to get back on the road as I'm in work tomorrow the other side was fine do you think this one will be better to fit ? I will change it again next week when the guy in landy shop is back

Are the sided ?

No they are not sided.

Where are you, someone may have in ether can lend/sell you.

mstd5 said:

No they are not sided.

Where are you, someone may have in ether can lend/sell you.

Click to expand...

Cheers

I'm just going to fit this one an buy one next week a change it and just redo the seal

thanks