Handbrake release mechanism

Hi,

I've managed to over extend the hand brake release mechanism whilst removing the centre console and now - of course - it wont work. Other an getting a new one, any suggestions on how to fix it.

Cheers

Mark

If you look at the base of the lever where it 'splits' into the two sides there's a cog with a pawl (ratchet brake) that's gone the wrong side of it. Use a small screwdriver to lift the pawl up and over the other side of the cog and push the lever forwards and down from the top, it should get a bit tight and then spring over with a bit more pressure ... don't force it, it's not like you need to swing on it, just persuade it a bit ..

When you're trying to re-fit the cable, use a small screwdriver to lift the cable eye out, then use a very small open ended spanner to hold the eye out from below while you put the eyebolt through the lever holes and eye.