got to do some chassis repair what do you think is best

i would like to know if i can use a tig welder to do my chassis repair as i cant there being a problem as long as it is clean enough
or should i go out and use it as an excuse to buy a mig welder
i got to do the front end and im a welder by trade so was thinking it would be ok.
cheers jake

Access rather than strength will be the issue mig easier in confined spaces

tig welding is by far a better weld if done correctly as you well no
but for chassis work you want a mig ideally
what tig welder do you have? do you have the mma lead/torch?

hmm i c your point, i was thinking i would be able to get in there wiv the wings off though oh well i will wait for the money from my motorbike accedent to come through the door and buy a new mig welder . then i can cheat n keep as much bodywork on as possible

gcoo8154 said:

tig welding is by far a better weld if done correctly as you well no
but for chassis work you want a mig ideally
what tig welder do you have? do you have the mma lead/torch?

Click to expand...

i work in a ship building/repair yard so i no they are big sets but to be honest i havent looked at them to study what they are i no its made by murex though

i could do with a mig for at home anyway
cheers

jake04551525 said:

i work in a ship building/repair yard so i no they are big sets but to be honest i havent looked at them to study what they are i no its made by murex though

i could do with a mig for at home anyway
cheers

Click to expand...

ah fair enough
and for the time side of things mig comes out on tops again

i dident even think about that lol, im used to getting into akward tight spaces wiv mig or stick gear so i should get away with leaving most of the bodywork on as i have checked the extent of the rot allready :bounce: