gearbox

markdewey · Dec 24, 2009

Hello all

Have just joined your forum by recommendation I have a question.
My Land Rover Discovery 300 Series I can no longer select 1st, 3rd or 5th gear I have replaced the small plate that separates the springs at the base of the gear knob no improvement any ideas or suggestions? Much appreciated.

Mark

nickh75 · Dec 24, 2009

ya gear box is fooked mate
buy a new/ second hand one an fit it
job sorted

uncle albert · Dec 24, 2009

presume bias plate intact when you took it out? if not did you get inch square tag out or has it gone under gear lever hint hint as this can block gear changing. basicly tag breaks off and falls in you can normaly get it with slim fingers or pliers

markdewey · Dec 25, 2009

Thanks Uncle Albert there was a piece of metal as you suggest I removed this and carrying on driving the car without any problems, but since have lost gears, now replaced plate and still no gears 1st, 3rd & 5th. Thanks for your help with this. Mark

markdewey · Dec 25, 2009

to nickh 75 thanks for your advice which is probably correct but i was hoping for some one who could give me some technical advice on what may need replacing inside the box cheers mark

The Mad Hat Man · Dec 25, 2009

It is difficult to diagnose problems that are as obtuse as this, however it looks like your gearlever is unable to go forwards, judging by the lack of first, third and fifth. Suggesting something is blocking selection. To investigate forther you need to remove the selector mechanism andlook inside the gearbox. You maynot have refitted it back properly.

Pics might help.

James · Dec 26, 2009

I agree with Mad, you can open up enough with the box inplace working on the inside of the car.

Could be the bias plate is not quite in position and this makes it harder to select.

gearbox

markdewey

New Member

nickh75

Well-Known Member

uncle albert

New Member

markdewey

New Member

markdewey

New Member

The Mad Hat Man

Well-Known Member

James

Active Member

Similar threads