dessmitton
New Member
- Posts
- 4
Series 3 refuses to go into gear and the noise coming from the gearbox sounds like a ballbearing rattling about noise stops when clutch in pressed any ideas?
Gearbox problem
- Thread starter dessmitton
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Release bearing or pressure plate at a guess. You might be lucky and it'll be the clutch run dry or a failed master/slave cylinder which is easier and cheaper to fix. Is there any fluid in the master cylinder or any signs of leakage from either cylinder?
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
will gear stick move in all gears ,you have 3 selector shafts if one is out of neutral position even by a bit interlocks wont allow you to select any gear,check under gear stick all shafts line up and not half in gear, you also could have worn brgs ,more info needed
dessmitton
New Member
- Posts
- 4
cheers think i found problem a snapped spring
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
so you was trying to select 2 gears
dean68uk
Active Member
- Posts
- 525
- Location
- Gosport Hants UK
I had this problem which was the primary bearing cage breaking up. It still worked though!
ciderman
Active Member
- Posts
- 768
- Location
- sunny worcestershire
When I drained the oil , ball bearings dropped out!- time for depression....
ciderman
Active Member
- Posts
- 768
- Location
- sunny worcestershire
Apols- this was another land rover I own, not the current juddering......
Similar threads
