Front disc change question

Paul.G · Jun 22, 2018

I have bought new discs, pads and fitting kit, will I be able to change them without damaging the wheel bearings and seals as they where only changed a few months ago?

FIREAPPLIANCEMAN · Jun 22, 2018

You dont say which vehicle, but the simple answer yes you will be able to fit them with out any damage to your hubs,
That is of course if the last person didn t weld them on LOL

bankz5152 · Jun 22, 2018

Without damage yes. Without disturbing no. As the whole hub has to come off in order to change the disc.

Disco1BFG · Jun 22, 2018

Paul.G said:
I have bought new discs, pads and fitting kit, will I be able to change them without damaging the wheel bearings and seals as they where only changed a few months ago?

With care, yes. keep everything clean, and it'd be worth watching one of the land rover toolbox type videos on you tube...

dag019 · Jun 22, 2018

If you are careful with removal and refitting there shouldn't be a problem with the reusing the bearings and seals. the bearings should be fine regardless but it is easy to damage the seal.

Paul.G · Jun 22, 2018

Sorry it is on a 2000 Defender 110 TD5, I have been looking for a full video on Land Rover Toolbox, his how tool's are usually very informative but the one I saw never showed from the start, do I remove the drive flange then remove the hub nut?

TorsionBhudda · Jun 22, 2018

I would change the seals just to be on the safe side they don't cost much anyway

FIREAPPLIANCEMAN · Jun 22, 2018

You could have a look for a video on how to do it on you tube

Paul.G · Jun 23, 2018

So after another search I came up with this informative how to, hope it is ok to share it, the problem I had was I was unsure how to remove the hub, now I know, thanks for all your reply's guys

Front disc change question

Paul.G

Active Member

FIREAPPLIANCEMAN

Member

bankz5152

Well-Known Member

Disco1BFG

Well-Known Member

dag019

Well-Known Member

Paul.G

Active Member

TorsionBhudda

Well-Known Member

FIREAPPLIANCEMAN

Member

Paul.G

Active Member

Attachments

Similar threads