Freelander 1 Transit mode
- Thread starter bigdee52
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
CJ2a
Well-Known Member
- Posts
- 1,369
- Location
- the Bieszczady mountains of Poland
Hi welcome to LZ there is a way its called burn it and buy a proper land rover or just go down to a garage with diagnostics reader and they will clear your fault or tell you whats wrong
gas
Well-Known Member
- Posts
- 1,348
- Location
- peterborough
start engine
put lights on full beam
including fog
sound horn 5 times
switch off
get out drivers door lock it
unlock car and enter through boot door
then do same again
but do horn 10 times
usually resets the buggers
put lights on full beam
including fog
sound horn 5 times
switch off
get out drivers door lock it
unlock car and enter through boot door
then do same again
but do horn 10 times
usually resets the buggers
jonny2tanx
Active Member
- Posts
- 478
TRXnMe
Active Member
- Posts
- 476
- Location
- Newport, Gwent
Hello and welcome to the LZ 
Pop over to the introduce yourself bit and do just that, then take a look in the Freelander specific forum, search is useful and might provide an answer to your problem.
Folk on here can get testy if you don't do the introduction bit, they will then get even more annoyed if you don't use search, especially if your fault turns out to be quite common
Pop over to the introduce yourself bit and do just that, then take a look in the Freelander specific forum, search is useful and might provide an answer to your problem.
Folk on here can get testy if you don't do the introduction bit, they will then get even more annoyed if you don't use search, especially if your fault turns out to be quite common
CJ2a
Well-Known Member
- Posts
- 1,369
- Location
- the Bieszczady mountains of Poland
ridgeways of rotherham sounds like a dealer or a specialist (they charge specialist prices to) if i were you i be would finding a good mechanic that you could trust or if you know a good mechanic then take it to him and get it on thier diagnostic machine (should haave the software for the Freelander 2) and should be able to reset it good luck
