Floppy knob

right guys i think i have bust summat.. the transfer lever has gone floppy, it goes into high and low ok but its floppy side to side, done a search but only seen posts for broken levers, any clips or screws that could have come off or have i bust summat.. tried to look at the pics on the thread i found but they were not available. bit stuck at the min and i have a sponge holding it out of diff lock btw the light works ok when it does go over into lock but not sure if lock is actually engaging. did a bit of extreme stuff last sat and it went floppy then.
andy

My guess would be the ball and seat are worn at the bottom of the lever.

Checked in the manual and the following is a pic of the transfer lever assembly, might help.

dont kno if the 200/300 are the same mate, but same happend on my 300 it, there is a threaded rod that runs into a clamp thing, with a 13mm nut on the end, mine came loose and sounds like the same thing here.

heres the link mate, theres a pic on there with an arrow to the part im talking about, old post of mine.

http://www.landyzone.co.uk/lz/f8/part-number-hi-lo-box-help-69730.html

cheers guys gonna be busy then..lol rear brakes to overhaul as well as sorting the lever out..ahh the joys of landy ownership...never had this problem with me slitty..just kept going..lol