Disco 2 flat air bag

Time for new ones.

Got dunlops.

So what is needed to fit normal bags?

There's a good write up for this job on the Discovery2 .CO.UK site, I followed this when I did mine.

http://www.discovery2.co.uk/Rear Air Springs.html

You can jack up one side at a time and no need to undo the pipes at the valves cos it's possible to hurt the o-rings there and create a leak in vain, once jacked up enough you can release the air at the bag's connector without any probs then swap the bag, push in the pipe and job done

Good point, I didn't undo the pipes at the valves, just undid them at the airbag. The ones I took off had a compression type connection, whereas the new ones were push in.

My dunlops are push fit, but if the new ones are not how do i convert back?

Left dunlop is leaking

check if you can unscrew the push fit connectoor from the dunlop and then you can swap it with the voss connector of the new bag or you can find push fit PC4 - M8 connectors like in the pic... just make sure about the thread cos i'm not 100% convinced that it's M8 1.0 or 1.25 or other in the bag, must be the same like the voss

They still sell Dunlops so for sake of 50 or so I am getting them fitted on Thursday.

I need rear half chassis. Holes behind the airbags.

Patch it.....

Sell it.... lol