Fitting a bulkhead removal bar.

Has anyone fitted one of these? What's involved? Is it nesessary to remove the tub or can it be done by cutting out the bulkhead from inside the vehicle, then fitting the bar in its place?

I want to fit some comfier seats, but at 6'4" and 16st, I'll need to move them back a bit more. I've already lifted the seats and moved them back as far as possible with the bulkhead in place, so now I need to get a bit more radical.

Any advice gratefully received.

cut a dodd oot yer legs

I know I said any advice gratefully received but...........

I've seen one fitted and he just removed the seats and cut the bulkhead out to suit the shape of the bar.

http://www.northoffroad.co.uk/bulkhead-removal-bar.pdf

DIY Bulkhead Removal Bar - Land Rover UK Forums

Log in

slob said:

Log in

Click to expand...

Try this then unless yer bin banned from ere as well Land Rover Restoration | Series III rebuild | Nick's Land Rover

Thanks again Pikey.
There seems to be 2 types. One allows just the top part of the bulkhead to be removed for about £100, whilst the other, which allows complete removal is about £400. There doesn't seem to be much difference in terms of additional seat space / movement and the cheaper one seems a lot less work to fit.

can you not make one up fer a lot less. seems simple enough, dollop of round tube and some flat bar.

no welder, no tube bender, no sense.

anyways - i registered and logged into that uvva site an there is no fecker there!

no nails?