fabricating exhaust.........

batfink82 · Sep 13, 2006

Hi, just looking for some ideas.....Im still trying to work out how i connect my original LR manifold to a tractor silencer. The silencer has been hung underneath the passenger seat so I only need a short length of pipe. But the problem comes in the bore size change. The manifold has an internal diameter of 35mm, whereas the tractor silencer is 65mm internal. Does anyone have any cunning plans of how I can make a joining section? I'm pretty handy with a MIG but I dont have a pipe bender.

slob · Sep 13, 2006

why not buy another box with the right size pipe or even better get a new exhaust they ain't that dear§

yella · Sep 13, 2006

send a pm to grey battle bus, i remember him doing this on a series 3(or was it a 2.5td) ah well ask him anyway

batfink82 · Sep 14, 2006

thanks for the contact. i think i have come up with a way of doing it now.....

http://www.merlinmotorsport.co.uk/EXHAUSTS-JETEX-2.5-Inch-Diameter/c223_224_226/index.html

i'm going to use some bits from merlin motorsport to make up the section i need.

fabricating exhaust.........

batfink82

New Member

slob

Well-Known Member

yella

New Member

batfink82

New Member

Similar threads