Hi
I have recently change my injectors in an attempt to stop it smoking on hard accelerating, and now it wont start. I have blead the fuel filter, pump a few times now and it would appear to be fine with no air.
It did start fine before I changed them.
Two questions I'd like to ask, how tight should the injector nuts be, and can overtightening them cause them to not seal properly. I did fit new steel and copper washers.
It does fire and really tries but just wont start. Any obvious reasons why ?
Would be grateful for any advise.
Many thanks
I have recently change my injectors in an attempt to stop it smoking on hard accelerating, and now it wont start. I have blead the fuel filter, pump a few times now and it would appear to be fine with no air.
It did start fine before I changed them.
Two questions I'd like to ask, how tight should the injector nuts be, and can overtightening them cause them to not seal properly. I did fit new steel and copper washers.
It does fire and really tries but just wont start. Any obvious reasons why ?
Would be grateful for any advise.
Many thanks