- Posts
- 2,427
- Location
- Isle Sheppy
Key lost sync tried it in ignition and pushing fob but no joy would leaving the boot open for couple of hrs cause this as was working fine day before
P38A Engine disabled
- Thread starter pete12345
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Possibly, if it's dropped the battery low enough. Think you need to enter the EKA.
Do you have the EKA? If so, you can enter it via a series of lock/unlock turns of the key in the drivers door PROVIDING the switches are all working.
Is this diesel or petrol, there are some differences in how the alarm/immobiliser system works on the different engines.
Do you have the EKA? If so, you can enter it via a series of lock/unlock turns of the key in the drivers door PROVIDING the switches are all working.
Is this diesel or petrol, there are some differences in how the alarm/immobiliser system works on the different engines.
- Posts
- 2,427
- Location
- Isle Sheppy
It's petrol I've got a nanocom so will resync was just wonder why it was ok in the evening but nothing next morning will check battery as well thanks
I've disabled mine for now as it spends long periods not being used and I got sick of having to get the book out to find the eka and enter it.
Often, there's enough juice to start it once the eka is entered but it got low enough to loose the eka. I was quite surprised that it happened like that.
Often, there's enough juice to start it once the eka is entered but it got low enough to loose the eka. I was quite surprised that it happened like that.
- Posts
- 2,427
- Location
- Isle Sheppy
Just put EKA code into nanocom car started fine checked battery 14:5 is that ok output on tick over resync the key in drivers door it locked on fob once and unlocked but wouldn't lock again when I tried it any ideas much appreciated
- Posts
- 18,967
- Location
- Buckinghamshire, UK. ('95 DT)
14.5V charging is right for the petrol.
Fob, no idea. Button on fob? Or fob battery?
Fob, no idea. Button on fob? Or fob battery?
rasheed
Well-Known Member
- Posts
- 1,815
- Location
- Bangladesh
In increasing levels of pain:
Fob battery
Door microswitches
Eprom chip starting to fail in BECM
Fob battery
Door microswitches
Eprom chip starting to fail in BECM
Rick-the-Pick
Active Member
- Posts
- 782
- Location
- Hove, Sussex.
Fully charge your battery, then try again. Having the tailgate open has stolen the amps out of the battery.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Don't forget the white block connections at the bottom of the A posts behind the kick panels, mine were corroded so I cut them out and soldered the wires.unlikely but possible, mine was standing for years.
- Posts
- 2,427
- Location
- Isle Sheppy
Thanks for all the suggestions hope your right Rick the pick seems the cheapest option I've used the car today and all been good with fob but will replace batteries just in case got to go to Scotland nxt week in the car with a trailer so don't need any problems on route fingers crossed
