Dynamic Response bleeding.

Has anyone bled the hydraulic system on Dynamic response other than getting a dealer.
This is on an L320 RrSport, I have just fitted new set of front hyd pipes. Refilled reservoir with 75 % of 1L .It not going anywhere. I know the valves have to be opened and then bleed electronically by opening the appropriate bleed points. Has anyone know of a DIY method.

Hi

assume ur talking about the Active Stabilization System , heard there are some workarounds , however as it’s a safety factor best to get a garage to bleed the system that has the specialist electronic device’s

Ok I get that , but I need to know that there isn't a stying of other faults lying in there to prevent the process of bleeding.

Can I assume that because I have pressure sensor fault c1A09-16 that comes up can be of two things either its locked out because of air introduced by changing the pipes and introducing new fluid or isnt working at all and not allowing circulation. The air suspension is not happy either. There is no movement looking into the reservoir