Dmf
- Thread starter starfish
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
j the range
New Member
- Posts
- 3,927
- Location
- liverpool
try emmots of clone, if you need the number just ask..
craig_midz
New Member
- Posts
- 79
- Location
- walsall
no u cant mate well u cant from our suppliers anyway
Datatek
Well-Known Member
- Posts
- 45,015
- Location
- Near Poitiers SW France
Hi does anybody know if you can get a convertion flywheel for a p38
2.5 dt hears hoping
If you mean a solid flywheel to replace the DMF, it's not a good idea, likely to cause crankshaft failure due to the lack of torsional vibration damping. There have been several reports of this happening on the tdci Transit engine when solid flywheels have been substituted for the DMF. It's reasonable to assume that the risk of failure would be much greater on an in line six
theoretically perhaps, but in the real world not so
that's why Rakeway are selling so many of the TD5 conversion kits to peeps disgruntled with numerous DMF failures
Flywheel & Clutch Kits
- Posts
- 58,170
- Location
- Preston Lancs.
If you mean a solid flywheel to replace the DMF, it's not a good idea, likely to cause crankshaft failure due to the lack of torsional vibration damping. There have been several reports of this happening on the tdci Transit engine when solid flywheels have been substituted for the DMF. It's reasonable to assume that the risk of failure would be much greater on an in line six
Are you sure these failures are due to fitting a replacement solid flywheel or the welding up (out of balance) of the DMF. All the torsional vibration damping required is taken care of by the springs in the clutch spinner plate. As is has been for very many years before LUK invented the abortion that is the DMF. The DMF is designed to smooth out the power flow and prevent transmission damage at low RPM in high gears. With the engine spinning freely (being in the correct gear) a solid flywheel should make no difference to torsional vibration. I am amazed that manufacturers still use this ridiculous system.
Do some research first, transits with solid flywheel conversion snap cranks due to harmonics.
Well known issue
- Posts
- 58,170
- Location
- Preston Lancs.
So they fitted the DMF and designed a weaker crank to use it with. How the hell can a mouth organ snap a crank?
Similar threads
