1968unclefester
New Member
- Posts
- 430
- Location
- faversham kent
i can do a few wading kits for discovery 1
£25inc post or £20collected
if your axle / gear'box is hot and you go into cold water it can suck water into casings
most kits only do only axles ,
i can do a kit to do , both axles , transfer'box , gear'box , wading plugs with dowty seals
you get
4 x 6mm push fit joiners
10 mtr 6mm plastic hd pipe
2 x 6mm push fit t piece
2 x 1/4 bsp plugs / dowty seals for timing cover & clutch housing
1 x packet cable ties
ADVICE GIVEN IF NEEDED
easy to do , find end of orignal breather cut end straight push joiner on and run new pipe to wher ever you fancy and cable tie in place , i didnt use t'pieces on mine just ran all four through screen trim and to top of snorkel you can use t'pieces so you only end up with two ends not four
wading plugs just screw into bottom of timing cover and bottom of clutch bell housing
£25inc post or £20collected
if your axle / gear'box is hot and you go into cold water it can suck water into casings
most kits only do only axles ,
i can do a kit to do , both axles , transfer'box , gear'box , wading plugs with dowty seals
you get
4 x 6mm push fit joiners
10 mtr 6mm plastic hd pipe
2 x 6mm push fit t piece
2 x 1/4 bsp plugs / dowty seals for timing cover & clutch housing
1 x packet cable ties
ADVICE GIVEN IF NEEDED
easy to do , find end of orignal breather cut end straight push joiner on and run new pipe to wher ever you fancy and cable tie in place , i didnt use t'pieces on mine just ran all four through screen trim and to top of snorkel you can use t'pieces so you only end up with two ends not four
wading plugs just screw into bottom of timing cover and bottom of clutch bell housing
Last edited: