Disco sill problem

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

rollin danny

Well-Known Member
Posts
1,231
I gave my Disco to a mate to sort out the welding on the rotten sills for the MOT. I gave him two pieces of box section 125mm x 60mm, 1.4 m length. He,s just been on the phone saying they wont fit :confused: He said he cant cut bottom of A and B pillars because its structural . Cant understand it as everyone on here said that was the best size steel to get. Now he says he will have to do the sills with steel sheet instead.
 
The bottom of the A and B posts are attached to the sill but not part of it. There is a lip that curls under the sill by about 10mm or somethin and its all spot welded. If delicate with an angle grinder you can cut around the posts and just chop the surrounding sill out then weld the new one back in. Either he hasn't really looked at it properly, or cant be bothered to cut around it all. I did my own sills not too long ago and it isnt really a hard job
 
Back
Top