disco 1 front seats into a 90

hi

will disco 200tdi front seats fit straight into my 90
if so do i need to any mods
will i be able to get at the battery if i fit disco seats

many thanks

no yes and maybe

Ey yup Yella.

ello grunt, how yer doin mate

Becks Bear said:

hi

will disco 200tdi front seats fit straight into my 90
if so do i need to any mods
will i be able to get at the battery if i fit disco seats

many thanks

Click to expand...

Question 2 dint make sense cos if the answer to Q1 is yes then the answer to Q2 is no and if the answer to Q1 is no then the answer to Q2 is yes. So it were pointless asking it in the first place.

ya need sum steel box section to mek a subframe up to ya seatframe

Why not use the rear seats?

or seats from a subaru imprezza -

Has the bulkhead been removed to get those in?

busterbus
do the rear seats fit

as for the questions i have a disco which i am using as a donor vehicle and was hoping to use as many parts from it to improve my 90, thereby keeping my costs to a minimum

always remember there are no stupid questions and i have no doubt i will be asking for more advice, but many thanks for the input and the help

busaboy said:

Has the bulkhead been removed to get those in?

Click to expand...

If you look at the gap between the seats you'll notice the bulkhead is still there. Or appears to be, unless he's stuck a sheet of ply in. Dont forget scooby seats are very thin.

Becks Bear said:

busterbus
do the rear seats fit

as for the questions i have a disco which i am using as a donor vehicle and was hoping to use as many parts from it to improve my 90, thereby keeping my costs to a minimum

always remember there are no stupid questions and i have no doubt i will be asking for more advice, but many thanks for the input and the help

Click to expand...

Should do, Ah put range rover ones in mine

Have a look in me gallery or check out STEVES SITE

busaboy said:

Has the bulkhead been removed to get those in?

Click to expand...

I've got a MUD bulkhead removal bar fitted yes, but that's so that I can get the seats further back (I'm 6'4" and 16st). They would have fitted without this, but about 3" further forward.
The MUD bar is quite cheap (£99) and easy to fit, but only removes the top half of the bulkhead. However, that's all you need to move the seats back.

Incidentally, the fixings for the scooby seats are the same spacing as the LR ones, so they're a piece of **** to fit. I used some 1" box section so that I could get them a bit higher and further back.

I need to order a load of stuff from mudstuff, already fitted a dash thingy, good products.