Disco 1 Caliper

Hi
Looking for assistance.Ive removed both front calipers for replacement.However.The ones I ordered and then sent back only to be given the same calipers with Two feed pipes.The ones I removed had only one fees pipe.Can anybody provide me the correct part no or can I blank off one of the feed entry points? Thanks in advance!

When I've put rrc axles under 90's in the past I've just joined both pipes together in a T piece . never had any trouble with em

Cool the problem I have is I only have one pipe.however my replacement calipers require 2.Should I be ok to blank off one pipe entry point on the caliper.

A lot of vented callipers come with the two pipe configuration, and no u can't blank one off, u need two fluid feeds so as stated a small mod of a T piece is required. Your existing pipe splits via the T piece to provide two feeds into the new calliper.

If your new callipers are for solid disks then send them back and get the correct ones for your disco 300 series as it not worth the trouble carrying out the pipe modification in fitting 200 series/RRC callipers.

Yeah don't mess with brake callipers send them back, I think the twin pipe fed ones came off of the older 200tdi discos, as the 300tdi has one brake pipe, I found this out when I was gonna swap callipers from a 200tdi to 300tdi.

the part numbers are stc1962 and stc1963.
they are the part numbers for non-vented front calipers.

Cheers for the assistance guys I'll order the proper ones.i was just gonna fit an additional bleed nipple to each caliper bit I'll go with the other ones.

Calipers in and fitted! Need to replace my brake pipes I damaged though.getting them made tomorrow.