Dirty buisness

bet that got your attention .
is under body protection avaible for the p38 hse like stering guards and the such cant seem to find any

not much about, youd be best fabricating your own!!

With so much availabel for the rest cant belive the p38 has been overlooked

its more a case of nobody really buys it, after all there is no need on the gravel drive rr owners call off road!

Ok looks like it could be a no hoper then . Cheers

get yersel some galvanised steel and a couple od sheets of ally and make a full under body protection system, then get someone to make a few up and flog em on fleebay!!!

Sounds a plan but wouldnt know where to start

start with 'some galvanised steel and a couple od sheets of ally' :hysterically_laughi

nathan5346 said:

start with 'some galvanised steel and a couple od sheets of ally' :hysterically_laughi

Click to expand...

your point bieng???

I was saying the exact same thing before. I'm going to be looking at how a disco 1 and 2 winch bumpers are fitted onto discos. Don't know if its the same as on the P38, so might be able to fabricate something. Same with steering guard, etc. However, after taking a look under my car, I have tubular bars in front of my diff and steering so it looks like they're already covered?

i was thinking more of a skid pan drom bumper bottom to bottom of axle and then a little piece for beneath the diff??? then a flat sheet to the rear diff and same again for diff then another skid pan to the back bumper!!

gavbriggs said:

your point bieng???

Click to expand...

he said he wudnt know where to start so i put what you said, i wasnt makin a point just a funny comment u obviously missed, or to put it simpler you suggested where to start and they said they wouldnt know where to start... get it now? dumbass

ok ****brick

` Tubular bar in front of axle`, thar`ll be yer anti-roll bar not yer anti-rock bar!!
Think factory made winch mount for P38. Take off bumper mount winch, replace bumper. Job done. Then pay garage factory size bill! Very neat , but you gets what you pays for: gets a lot, pays a lot.
Some very interesting bits of kit available Stateside & Aus. Checkout `rangerovers.net.`
I am thinking about getting some things made up myself. I know I haven`t got the skills to do a good job myself or the tools for bashing 1/4" steel tube. Got some agricultural garages around here, so gonna save up some cash, draw a picture on the back of a fag packet, see what happens....

gavbriggs said:

ok ****brick

Click to expand...