Rookiescot
Well-Known Member
- Posts
- 1,436
- Location
- Scotland
We got a brand new 110 in the work and its sometimes difficult to put it into low ratio.
Is there a trick to this?
Is there a trick to this?
Difficult to engage low ratio
- Thread starter Rookiescot
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
abcdedd
New Member
- Posts
- 785
if it doesnt first go in, put it into 1st, come up on the clutch a little and then back down again the try again..
Rookiescot
Well-Known Member
- Posts
- 1,436
- Location
- Scotland
Thanks mate ...I'll try that next time. 
abcdedd
New Member
- Posts
- 785
no worries, not garunteed, but helps me sometimes
top drive
Well-Known Member
- Posts
- 2,694
- Location
- Peoples republic of culter
mines got 130k on the clock and an entirely different gear box but i sometimes have to go to first gear and push the transfer box stick to where i want it while lifting the clutch to get it in.
timtheenchanteruk
Well-Known Member
- Posts
- 4,633
- Location
- Leeds
same for me,
AFAIK the transfer box gears are straight cut sides, so if they are out of line, they wont engage, doing wither of the above moves things around, and they usually go in the 2nd time around.
AFAIK the transfer box gears are straight cut sides, so if they are out of line, they wont engage, doing wither of the above moves things around, and they usually go in the 2nd time around.
Steve_R1979
Active Member
- Posts
- 634
- Location
- Horsham, West Sussex
As above!!!
