Defender Wheel Carrier (Rear Door) Thread / Nuts?

[JAKtheLandy]

Defender Wheel Carrier (Rear Door) Thread / Nuts?
Hi All,
I have bought and fitted a second hand Rear door Wheel Carrier for my 110 Defender Td5.
However I can't work out what Nuts I need to secure the wheel on.......
I have tried my 110 wheel nuts and my wife Discovery ones...... The thread on the carrier looks much finer than either of the ones i have tried but about the same diameter......
Your help to identify what I need and where i can get some would be appreciated....
Thanks in advance.

 

[lynall]

You might find its off a series motor?
Im not sure if different threads but guessing.
The early series 2 were smaller studs, s3 went to larger ones, but not sure if same thread as 90/110/defender models?

 

[jamesmartin]

series 3s are the same thread as defender,d1,rrc

 

[JAKtheLandy]

This is the thread...

 

[lynall]

Thanks James I wasnt sure

 

[lynall]

If you measure the outside diameter and the thread pitch someone my be able to help?

 

[JAKtheLandy]

it is about 15.9mm or 0.6259843" and is about 15 or 16 threads per inch......

 

[Doey68]

The first thread is knackered on that stud. You won't get any nut to fit it. It needs a die running down it.

 

[lynall]

A thought has just crossed my mind shocking I know!
Have you looked at the other end of the stud in case it has been replaced with a bolt?

 

[JAKtheLandy]

Good point Lynall, no i haven't, thank you.
Doey68, Yes i had thought that but nuts i have won't give it a look.....

 

[aaronmorris]

Standard thread is M16 x 1.5 from memory, but not sure that even helps in this case.