Defender engine swap 200tdi temp sender

scrappyloz · Jul 12, 2012

As some of you may know me and chunkymunky recently fitted a 200tdi into his early defender 2.5td.

I cant seem to get the temp gauge right, it was showing just below red on the standard 200tdi sender so it was replaced with sender PRC6663. It is still reading about 3/4 when warm even though the radiator bottom hose is only luke warm.

What sender should he be using that is compatible with the defender gauge and disco 200tdi engine

landowner · Jul 12, 2012

I used the 2.5td sender in my 200 conversion

200tdi ayre · Jul 12, 2012

yeah use the sender off of the engine it replaced as it is calibrated to the guage correctly

chunkymunky · Jul 12, 2012

we would have but it kinda snapped in the injun :/

anyone know the code?

200tdi ayre · Jul 12, 2012

PRC2505
hope its the right one

chunkymunky · Jul 12, 2012

ok will grab it tomorow. its in for mot today

scrappyloz · Jul 23, 2012

Fitted temp sensor PRC2505 and its still reading hot

Any other part numbers as i will go out and buy one today

tottot · Jul 23, 2012

Just buy a proper gauge that reads in degrees C with matching sender available for about forty tokens and see what your engine real temp is.

scrappyloz · Jul 23, 2012

tottot said:
Just buy a proper gauge that reads in degrees C with matching sender available for about forty tokens and see what your engine real temp is.

Its not my truck its chunkymunkys, Also i know that its not overheating as there is a thermostatic fan on there which doesn't come on and the bottom hose only gets luke warm

johns90 · Jul 23, 2012

could it be reading right and may have an air lock? Problem with thermostat?
you seem to be concentrating on the sender, could it be something else?

oil dripper · Jul 23, 2012

Been covered loads of times,general opinion was get a new sender from Steve Parkers who does the proper one for the conversion

scrappyloz · Jul 23, 2012

Defiantly not something else, its defiantly the sender. I will get him to buy one from Steve parker

chunkymunky · Jul 23, 2012

Will have a look when i get near wifi. No signal in these cursed parts!

chrisgem · Jul 24, 2012

let us no how you get on with this as mine is the same as you have described yours

chunkymunky · Jul 24, 2012

Have spoken to steve parker himself today. Prc6663 should have done it. He says he now recommends using disco sender with disco gauge or a stand alone.

300tdistu · Jul 25, 2012

Discovery 200tdi into Def90/110 temp sendor fine thread SPCK224T2 | eBay

http://www.ebay.co.uk/itm/Dvy-200td...arts_Vehicles_CarParts_SM&hash=item4605e649bd

chunkymunky · Jul 25, 2012

Mines deffo fine. Problem is i kinda made coarse go into fine thread so may have mullered it. Temp gauge is pretty unspecific anyhow figure i may try and put a stand alone unit in but with mud pof/dash as stereo is proud of dash and may fit cb at some point.

Its scrappyloz's fault, he made me go laning and now i wanna kit it out

Defender engine swap 200tdi temp sender

scrappyloz

Active Member

landowner

Pensioner Pete

200tdi ayre

Well-Known Member

chunkymunky

New Member

200tdi ayre

Well-Known Member

chunkymunky

New Member

scrappyloz

Active Member

tottot

Well-Known Member

scrappyloz

Active Member

johns90

Active Member

oil dripper

Well-Known Member

scrappyloz

Active Member

chunkymunky

New Member

chrisgem

New Member

chunkymunky

New Member

300tdistu

Well-Known Member

chunkymunky

New Member

Similar threads