Cylinder head off??

gR@HaM · Apr 12, 2010

If you're doing some head work on a 300tdi pls learn by my mistake and make sure you put front glow plug & (more importantly) water pump back on head before it's on the engine. Have had A right mare this evening which resulted in cutting bottom left m8 bolt short to get it through water pump, relocating a/c and chopping a 10mm spanner in half to get access :doh: :doh:

300tdistu · Apr 12, 2010

that's one way of getting round it,, lol.......

you know for next time

Norledge · Apr 13, 2010

Hang on... What??

The front plug is a mare, but you just undo the 4 13mm nuts holding the A/C pump on and pull it up out the way.

As for the waterpump... Just pull the Rad and intercooler out??

gR@HaM · Apr 13, 2010

Norledge said:
Hang on... What??

The front plug is a mare, but you just undo the 4 13mm nuts holding the A/C pump on and pull it up out the way.

As for the waterpump... Just pull the Rad and intercooler out??

One of the bolt heads had rounded on p/s unit and couldn't be arsed pulling rad and intercooler out when most of the discos already in bits.
Just trying to be if some help

gR@HaM · Apr 13, 2010

Anyway it's not that rad that's in the way!

Norledge · Apr 13, 2010

PAS pulley to? That just comes off too?

Norledge · Apr 13, 2010

gR@HaM said:
One of the bolt heads had rounded on p/s unit

Ohhhhhhhh...

Cylinder head off??

gR@HaM

Well-Known Member

300tdistu

Well-Known Member

Norledge

New Member

gR@HaM

Well-Known Member

gR@HaM

Well-Known Member

Norledge

New Member

Norledge

New Member

Similar threads