Coolant replacement and flush

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

bluedog333

Well-Known Member
Posts
5,432
Location
Henley on Thames, Oxfordshire
This weekend's job is to replace the coolant, coolant pipes and flush the system. I've got a tiny amount of oil lingering in the coolant from where the oil cooler exploded a while back, so I want to to a thorough job.
Any tips for a 100% flush, I know about the thermostat, but what are the other nooks and crannies I need to know about? Cheers all!
 
You could remove the rad to flush it maybe and use that as an excuse to remove and flush the intercooler.
There is a drain bolt on the block for the coolent system too, lots of crap/ water remains in the block if you don't remove that. Many , maybe all, are brass bolts so use a quality tool or you'll round it off.
 
This weekend's job is to replace the coolant, coolant pipes and flush the system. I've got a tiny amount of oil lingering in the coolant from where the oil cooler exploded a while back, so I want to to a thorough job.
Any tips for a 100% flush, I know about the thermostat, but what are the other nooks and crannies I need to know about? Cheers all!

Get a hose in and flush and reflush over and over. Oil in the cooling system is bad as it creates a film or oil spots on the water galleries, this then creates hot spots and poor cooling as the water is not directly in contact with the metal. Hot spots are worst as it can lead to increased heat in a localised area which can cause all sorts of issues due to expansion and contraction.

A drop or two of dish soap into the flushing water will help to strip it out - also adding a drop of soap to the fresh water and coolant will reduce the surface tension and help to keep the system running well. I have always had a drop of Fairy in my coolant. When I top up I also add a new drop.
 
Dishwasher tab, washing machine powder, kettle descaler all do a good job, run them with plain water then flush thoroughly before adding anti freeze.
 
Stick a wet vac on one of the hoses and suck it out. Hose one end, vac the other, should shift some build up.

I'm a plumber and often wondered about running central heating cleaner through the cooling system, might damage seals or gaskets though.
 
Back
Top