Conversion
- Thread starter jimcob
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
boydy1989
Well-Known Member
- Posts
- 3,063
- Location
- Northants/Oxfordshire/Warwickshire
Anything is possible with a big enough angle grinder!
90boy
Well-Known Member
- Posts
- 6,836
- Location
- Worcestershire, Tenbury Wells
yes you can a mate of mine did it.
was a bitch of a job and cost him a lot of money.
was dam good when it was all working and had a lot of power
DefenderItalia
Active Member
- Posts
- 105
Hi Dimitri - very good question as I want to do the same - I think there wa a series of articles on LRM or LR international, but the vehicle was built from the ground up using a tubular chassis and - yes the angle grinder was also used a lot to modify the bulkhead to allow the gear / tranfer box unit through too (it would be madness to connect the TDV6 to an older box) - I am sure the result would be awesome though - so yes if there is more information folks please pass it on!
kid regards, GG
kid regards, GG
wiltshire landyman
I’m back
- Posts
- 15,062
- Location
- salisbury plain wiltshire
as 90boy says anything is possible with a landy if youve got a money tree in the garden
