Ruby Range
Well-Known Member
- Posts
- 338
- Location
- Sandwich Kent
to continue i looked around this morning and have a compressor unplugged, a valve block, all 4 tubes to the four corners and a air tank. I could not see the height sensors (where would i find them) ? The real questions are what other major components do i need. Obviously the 4 bags which i figure at about £100 a corner but is there anything else i need to look for.
Also can i test the compressor by just re connecting it and seeing if it pumps out air to all four corners without upsetting anything. At present on start up i have the message EAS manual mode a bit of bleeping and then nothing else. the ride height switch do,s not illuminate when moved but the flat tyre symbol ?? next to it illuminates when pushed.
I would like to hear from anyone who has gone the reverse route to what most people do to see if it was a fairly easy job and was the ride so very very differant.
Also can i test the compressor by just re connecting it and seeing if it pumps out air to all four corners without upsetting anything. At present on start up i have the message EAS manual mode a bit of bleeping and then nothing else. the ride height switch do,s not illuminate when moved but the flat tyre symbol ?? next to it illuminates when pushed.
I would like to hear from anyone who has gone the reverse route to what most people do to see if it was a fairly easy job and was the ride so very very differant.
