CLutch Slave Issues

When you say the slave cylinder broke, do you mean it came off the bracket? If so, check the bracket. I had a similar problem where one of the "fingers" that hold the slave cylinder had stress fractured. If the complete finger isn't there then the slave cylinder will slip off under load and destroy itself. I fitted a new bracket and hydroalic system and the job was a good un.

Hope that helps,

Cheers, Dave

Thanks:

No it's not the bracket, it's the hydralic 'arm/rod' that seems to be breaking off. The actual cylinder is still attached to the bracket.

Clutch cross shaft seizing in gearbox casing perhaps....

I'd unsrw ur bracke and take a look a the conditon of it. the rod my be breking because it's at an angle due to a brke./bent bracket.