Clutch hydraulics

Taffy · Sep 6, 2013

Hi. Got question. My clutch pedal goes to floor when starting from cold each morning. After engine start and few pumping I get clutch back to firmness It is hydraulics problem or air vacuum ? I suppose bleeding first cold work if not maybe leak via slave ?

Taffy · Sep 6, 2013

Bleeding could work I mean

craigyb · Sep 6, 2013

Clutch has no vacuum supply

the_wolf · Sep 6, 2013

What engine is it?

craigyb · Sep 6, 2013

Try bleeding. If no change then master or slaves buggered

Taffy · Sep 6, 2013

2.5 n/a. Straight from army. The Wolf. Craig b yes good idea try bleed first. Will do. If not then overhaul of all systems might be the way forward. New master and Slave and flex hose.

craigyb · Sep 6, 2013

Taffy said:
2.5 n/a. Straight from army. The Wolf. Craig b yes good idea try bleed first. Will do. If not then overhaul of all systems might be the way forward. New master and Slave and flex hose.

They are a pain to bleed sometimes

Taffy · Sep 6, 2013

Yes I understand. My friend said once slave and master are installed and open bleed nipple at slave and get container ready with tube at bottom and get a two people. One at under ready to close off. And the second person to pour the fluid and let it run out at bleed nipple and yell stop pour once he closed the nibble and then do the normal procedure of bleeding with three down and up open and close etc.

jamesmartin · Sep 6, 2013

Taffy said:
Yes I understand. My friend said once slave and master are installed and open bleed nipple at slave and get container ready with tube at bottom and get a two people. One at under ready to close off. And the second person to pour the fluid and let it run out at bleed nipple and yell stop pour once he closed the nibble and then do the normal procedure of bleeding with three down and up open and close etc.

wouldnt suggest you listen to him too hard ,just bleed with a pipe and jar and open bleed nipple ,by pressing pedal down steadily ,then close nipple whilst pedal is returned to top then open and press again till no air appears ,sometimes its necessary to crack open pipe at master cylinder and bleed there till fluid appears again closing for upstroke of pedal

Taffy · Sep 7, 2013

Might try the oil can way. Drain all fluid out and then fresh dot 4 in oil can and pump up

Clutch hydraulics

Taffy

Active Member

Taffy

Active Member

craigyb

New Member

the_wolf

Well-Known Member

craigyb

New Member

Taffy

Active Member

craigyb

New Member

Taffy

Active Member

jamesmartin

Well-Known Member

Taffy

Active Member

Similar threads