Removals01
Active Member
- Posts
- 692
- Location
- Cornwall
Hi guys I hadn't move my ser 3 for a month got in it to move a trailer and the clutch wouldn't move absolutely solid any ideas?
Clutch gone hard!
- Thread starter Removals01
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
Flywheel rusted to the clutch?
tottot
Well-Known Member
- Posts
- 7,469
- Location
- west wales coast
When you say clutch solid it it that the pedal wont move down? Could be pedal pivot seized,or master cylinder seal breaking up and a bit blocking the fluid outlet,or like mine last year the flexi pipe collapsed inside blocking it.
Open the bleed valve, if the pedal won't go down the master cylinder is siezed, if the pedal goes down the master cylinder is OK, pop the slave out, see if it's siezed. If the slave is operating OK then it's in the bellhousing and it's probably a gearbox off job. Good luck!
Similar threads
