Chequer Plate

I will second mammoth being good but damn there expensive.

I used a chap of eBay and he was brilliant. Cut the aerial hole and re galvanised it after then sprayed it black for me.

Ill try and find him and get a link.

GINGE said:

I will second mammoth being good but damn there expensive.

I used a chap of eBay and he was brilliant. Cut the aerial hole and re galvanised it after then sprayed it black for me.

Ill try and find him and get a link.

Click to expand...

cant galvanize aluminum

Thor1950 said:

cant galvanize aluminum

Click to expand...

No, but you can anodise it. Didn't you know that John? Or perhaps the idea of actually being helpful rather than critical goes against all you stand for?

GRATCH said:

No, but you can anodise it. Didn't you know that John? Or perhaps the idea of actually being helpful rather than critical goes against all you stand for?

Click to expand...

big difference between the 2 Could you imagine the bag or worms if peeps start asking where did you get your aluminum galvanized Next they would be can i galvanize my doors

Look at what asking about what size tyres can i put on question

its been over a year since i bought them so there not on my ebay account anymore.

GRATCH said:

No, but you can anodise it.

Click to expand...

Thor1950 said:

cant galvanize aluminum

Click to expand...

What Gratch said, i must have meant anodise

Thor1950 said:

big difference between the 2 Could you imagine the bag or worms if peeps start asking where did you get your aluminum galvanized Next they would be can i galvanize my doors

Look at what asking about what size tyres can i put on question

Click to expand...

Yes exactly. Your post should have read:-

Thor1950 said:

cant galvanize aluminum but you can anodise it

Click to expand...

Helpful and constructive.

GINGE said:

its been over a year since i bought them so there not on my ebay account anymore.

Click to expand...

neigh worry mate ...the mammouth ones look good , just need to decide whether to have the gaskets to go underneath for that ' factory ' look or just nail em down ..

mudfever said:

neigh worry mate ...the mammouth ones look good , just need to decide whether to have the gaskets to go underneath for that ' factory ' look or just nail em down ..

Click to expand...

I didnt get the gasket choice with mine. I wil however be running a bead of silicon all round though. Just make sure the top and the underside of the wing are in good condition and clean before you do it to give your wing the best chance of avoiding rot.

mudfever said:

neigh worry mate ...the mammouth ones look good , just need to decide whether to have the gaskets to go underneath for that ' factory ' look or just nail em down ..

Click to expand...

would be a good choice to stop dirt water getting between the 2 surfaces and causing corrosion

Hmmm , also brainiacs , as my arial is only half the thing it used to be , can you just replace the metal sticky uppy bit or do you have to re-wire in a whole new one ??

mudfever said:

Hmmm , also brainiacs , as my arial is only half the thing it used to be , can you just replace the metal sticky uppy bit or do you have to re-wire in a whole new one ??

Click to expand...

Get one of them short flexible ones, easy to rewire just screw on fittings