Deetd4
New Member
- Posts
- 164
- Location
- Co. Down Northern Ireland
At some point in my S3's life it has had a hard knock on the front end of the nearside Chassis Section. The front spring hanger is sitting around 20mm lower on the near side than the off side. This didn't concern me until I was underneath and found a kink in the chassis where it has now started to rust badly. I was on the paddocks site and I can get a new section to replace it. So, when I lob the old section off and fit the new section should I fab a sleeve to go up the inside to add a little strength or will the section have a piece that will slip up the chassis section or how would it be best tackled? Has anyone replaced a section of chassis ?