Calipers

I've got a new set of calipers to fit. 2 done ok. The 3rd and 4th are causing problems.....I can't get the brake lines undone. The nuts are rounded off, not sure if it was by me or if thats the reason I couldn't undo them in the first place.
Any ideas?
Thanks

Get new brake lines and bin the old ones with the old calipers because you won't want to reuse them.

Do people normally make up their own pipes? Can't find the front ones for sale anywhere...

Yes, any motor factor will supply you with the pipe and ends, and a flaring tool if you haven't got one. Otherwise, a local garage will make them up for you.

as above..machine mart or ebay for the flaring tool, its cheap..

expect to #### the first few up..so practise on a bit of pipe first, you can re use the actual fittings that you buy.

once mastered saves a good few quids.

just remember the pipe will work harden if bended about a bit, so try to get the nends right first time..

pre 81 you will need imperial fittings, after metric..

Is the copper pipe sturdy enough for the rigid pipes fitting direct to the caliper?

Davegilsenan said:

Is the copper pipe sturdy enough for the rigid pipes fitting direct to the caliper?

Click to expand...

yes ,you could do entire system with it if you so wished

Thanks all. Time to go shopping again!