I am having a problem getting the plug and cable for the switch through the bonnet release cable hole.
I am using some wire as a means to pull it through, taped to the cable and plug with a small amount of gaffa tape, but even though I have bent a small amount of wire back toward the engine bay and taped over it well enough, I cannot get the damn thing through and the wire eventually separates from the plug / cable.
Maybe I will look at separating the plug from the cable and re-solder when the cable is through.
Any tips on getting it through without removing the plug?
I am using some wire as a means to pull it through, taped to the cable and plug with a small amount of gaffa tape, but even though I have bent a small amount of wire back toward the engine bay and taped over it well enough, I cannot get the damn thing through and the wire eventually separates from the plug / cable.
Maybe I will look at separating the plug from the cable and re-solder when the cable is through.
Any tips on getting it through without removing the plug?