Brake pipe route

Happy new year too you all..
i took my TD5 discovery for mot today and yes it failed.. needs new brake pipes. the long pipe that goes from front to back, does ant body know what route it takes.
better still trying to find a picture of it on the net
Thankyou all very much

there 2 that go front to back have a look under lh front wing and floor

Cheers mate... i had a quick look tonight. but could not see a deal... it seem to run from o/s rear then disapears over the axle along the chassis on the n/s..it does not look easy to access, then it joind near front wing... it just looks a night mare...
cheers antway mate

the one for rh side does go under the body across the cross member ,i make that one with a join on top of lh outrigger

I've done one on a 300tdi its not so bad once you get under there with a good light I shaped the front part first then cut my copper reel down leaving plenty just in case and bought new chassis clips these become brittle and broke other than new ends and a new two way splitter above the axel all was good all I needed was the flaring tool

It's not as bad as you think as long as you have the tools for the job ;-)

They are on top of the N/S chassis rail and not the easiest to access especially if you have EAS, but give yourself plenty of time and I hope it all goes ok.

i would like to thank you all for reading my post and getting back to me.... i am new on hear and have only usrd the site once before... thanks again gentlemen